Cutting The Stone
The value of wholesale diamond jewelry is dependent on the cut, which is something that jewelry wholesalers look at closely. Until modern times, diamond cutting in preparation for the creation of wholesale diamond jewelry could be accomplished only with diamond, due to that substance's hardness. Not only that, but the process was uncertain and involved an extreme amount of nerve-wracking, painstaking precision.
Today however, diamond that is used in wholesale diamond jewelry is cut with lasers, using computer-aided design. Nonetheless, it is still a precision process that requires not only creative vision, but precision mathematical calculations as well. It is why the creation of wholesale diamond jewelry is as much science as it is art.
Jonathon Blocker specializes in wholesale diamond jewelry and certified loose diamonds. He is known among jewelry wholesalers as an expert in his field. He is a consultant for GemFind.net, a trusted name in the jewelry industry since 1999.
I never like to hear of problems with jewelry work or even of problems the jeweler might have from customers who have no clue as to what is going on. Good communications is the general solution for either. In your case, first appearances tell me the jeweler may have done less than the best. Then again, I am not there and only working in my thoughts with the words you have sent. Refreshing it is to have questions with enough information to actually work on a viable answer.
I am curious about the prong setting being bent. Unless the ring has a prong setting made originally as part of the ring, not soldered into the ring band but cast with the entire ring, and the ring had to be resized several sizes smaller, there should be no problem with the setting at all. Once in a while with a "made in place setting" when a ring goes down more than 2 sizes the setting can spread apart and the jeweler will have to retighten the stone.
That is fact. To be bent in another matter and I cannot explain that. It simply should not be bent unless bent when brought in to the store in the first place. Then, the person taking in the job should have informed you of that and advised correction work to straighten the setting.
Solder lines and greyish marks. Generally, I see two reasons for these marks. The first is a solder joint and possibly too soft a solder or a mismatched color of solder was used. The line shows the solder color. Sometimes when too soft a gold solder is used, polishing will erode of buff away some of the solder leaving a demarcation line, a slight recess at the solder joint. The fact that the sizing joint showed to your eyes is evidence that the work was not done with due care.
Are you familiar with jewelry?
supply centre. Each year, many jewelry shows are held in HK. Guangzhou City in South China become Hong Kong's largest jewelry manufacturing base in the mainland as many Hong Kong twisted pearl necklace makers have moved to the area in an effort to find low cost and skillful craftsmen. In Guangzhou you can find what you need you can find freshwater pearl beads, cheap pearl strands, sterling silver pendant, tin cup necklace, cultured pearl bracelet, cultured pearl ring, cheap pearl earing, sterling silver jewelry, wholesale pearl pendant, coral bracelet …to meet your taste.
Orignal From: Cutting The Stone
没有评论:
发表评论